S0uthernrebel78

I'm going to be installing my winch cables soon and I am going to set it up so I can shut the power off to the cables as the winch will be used on a multi mount on my f150 and my 1990 lifted suburban, I could care less where i put the switches on the burb but i want a nice clean look on the f150 just wanted to see where other people mounted acc. switches and and how it looks

CrewCabKyle

I had my light switched left of my Cigarrette lighter. I recently took it out and replaced it with the remote Base adjuster. Very clean and very easy to install once youve done it. The center dash pops out, then just pop out the plastic peice holding the cigarette in and dril a hole.

kankles

if you have a model without a flow through console, underneath the coin tray there is that storage pocket that you can put anything in. so what i did was went to the junkyark bought that little storage piece, cut off the back, made a plate to go on front of it, closed it with apoxy and added switches. i believe i got a pic in my gallery...check it out tell me if you like!

steven13sweet

this is how i did it

CrewCabKyle

Mine is very similar to that above pic. Though I have the floor shift.

kankles

heres mine this is what i was talking about...ive fixed it up since this pic but its basically the same