Breen_Jake5.4

Bought a 3" level. Do I have to do anything else? "Shocks, away bar etc" and do I need read blocks

bourgeois1269

3" level will put your up wet control arms at an angle so great that they will rub the springs at every little and big bump, I would reconsider going with a 2 or 2 1/2" level and the kit should come with rear blocks

techrep

iTrader: (1)

2WD or 4WD ??

Breen_Jake5.4

4wd

Breen_Jake5.4

I read some reviews and it said if need nothing else

Bigg Countryy55

A 3in kit is gonna put a lot of stress on your cv axles you'll be replacing them and ball joints and probably UCA

Breen_Jake5.4

Immediate or after awhile?

Bigg Countryy55

The ball joints will wear over time along with the cv axles which 160$ a piece the control arms will take a lot longer but it's never good to have metal rubbing against metal not to mention the other excess wear it'll put on your suspension comments the max I'd personally go is 2.5

AceFord04

Upper ball joints are about $70 each due to the fact the upper control arm has to be replaced with it. So $70 x2 plus the $$ for the other stuff that was mentioned above.... It's not worth it for an extra .5 inch of lift.

If you did you go with a 3 inch "level" kit, you would need blocks or an add a leaf cause the truck wouldn't be very level lol

Breen_Jake5.4

I personally think a truck looks better when the front end sits a tad higher than the ***. And if it's bad I'll just make my own blocks at my work