Brandmaner

He's got a 2.5 level in front, and pretty sure he used spacers and small trimming to keep from rubbing.

2007SCrew

phan10m has basically the same setups as mine: .25" spacers and 2.5" level. There was no trimming on mine and I don't think so on his either. Mine rubs the sway bar at full lock, and I think his is similar.

2007SCrew

Truck looks great!

Sparkie04FX4

iTrader: (1)

Don't know if it counts cause its not exactly leveled, still bout a inch of rake, but here's mine with 3" hbs and 1.5" aal.

phan10m

All valid statements ^^


2.5 HBS level. 35" Toyo Open Country M/T. .25" spacers. I need to lift my rear up a tad as well.

06-STX

2 inch level 265 bfgs

Sparkie04FX4

iTrader: (1)

Get the 1.5" skyjacker aal kit from autoanything. best bang for your buck! and dont have to worry bout blocks doing any damage to the rear axle. plus you get a nice extra add on to the pay load cap! but with a coupon from autoanything, you can probably pick it up for around $125ish.

Lvjbuffet

Nice very nice trucks.

I put in CCW 2" level kit . The truck sits on 18" Crave 2 wheels warped in BFG,

phan10m

How hard is the install? Took me damn near 13 hours for the leveling kit .... Lol. That was because I didn't have real tools lol. I forgot my buddy has a big boy jack AND a compressor with everything which would've made that install 10x easier!!! Anywho, I was kinda leaning towards that AAL as well but just don't know what actually needs to be done to put it in, also haven't researched much on it. Kinda keeping the mods to a minimum after tires and programmer $$$$$

dufx4

I just bought an 04 f150 yesterday and it has the factory 18 inch wheels on Courser CTs. I was thinking about buying aftermarket wheels and 35s but was wondering the offset/wheel size to make the wheel stick out past the fender about an inch? Sorry if this was posted somewhere else the only thing I could find was wheel spacers but am wanting to go the safer route.