keypad help
10-07-2007, 05:09 PM
#1
Junior Member
Thread Starter
Join Date: Oct 2007
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
keypad help
Ok a quick question. The F-150 i just bought has keyless keypad but the card with the factory card is missing, and i was wondering if there is anywhere else i can get the code instead of the ford dealership?
10-07-2007, 05:10 PM
#2
FULL BLOODED AMERICAN!!!!
Join Date: Apr 2007
Location: Jacksonville, Florida
Posts: 5,179
Likes: 0
Received 2 Likes
on
2 Posts
Welcome to the site!! I don't think you'll be able to get a card from anywhere else due to the fact that only the dealership or Ford has access to all the codes on your truck.
10-07-2007, 06:33 PM
#4
08 February TOTM
Join Date: Nov 2006
Location: Dumfries, VA Member: #77
Posts: 3,184
Likes: 0
Received 19 Likes
on
7 Posts
It's located on the module. The module is located behind the rear seat on the right side for the supercab and supercrew models. If it's a regcab then it's located in the left rear quarter trim panel.
Trending Topics
10-11-2007, 10:07 PM
#8
08 February TOTM
Join Date: Nov 2006
Location: Dumfries, VA Member: #77
Posts: 3,184
Likes: 0
Received 19 Likes
on
7 Posts
Locate the plastic cover where the shoulder strap position is for the rear seat drivers and passenger side. It's that box sitting on top of the seat back. Remove the little plastic panel on top of it and remove the two nuts inside. Let the box dangle and lift up on the entire seat back, easier with two people. It's held in with clips that you just lift the seat back off of. The other thing you will want to do is to locate the release pin on the center seat belt (The mini buckle). It's toward the seat side so it's hard to see but just push a paper clip or wire up in there and the belt will release.
1) Remove the shoulder belt housing and let it hang
2) Detach the mini buckle
3) Fold up one of the back seats and observe the horizontal tube with the child seat brackets attached. Inside the seat back, just above this metal tube is another tube just like it. You need to slide a screwdriver up into the seat along that child seat bracket and over the bar inside the seat.
5) Lift seat back off. (easier with two people)
1) Remove the shoulder belt housing and let it hang
2) Detach the mini buckle
3) Fold up one of the back seats and observe the horizontal tube with the child seat brackets attached. Inside the seat back, just above this metal tube is another tube just like it. You need to slide a screwdriver up into the seat along that child seat bracket and over the bar inside the seat.
- Push towards the back as you pull down on the seat, then push the seat up (if you don't pull down it may not disengage the clip). There's a sizeable plastic clip back there that you'll be pushing on, maybe without even realizing it.
5) Lift seat back off. (easier with two people)
