Kenwood 6140 Install
#1
Member
Thread Starter
Kenwood 6140 Install
Hi Folks !
Just getting ready to install my 6140 in my 2007 FX 2 Sport with Back-up Camera.
I am looking for a tip or idea on running the Video cable from the back and getting it up to the dash so I can plug it into the unit. Any ideas or secrets where to enter into the cab that is easy to get up to the dash.
Appreciate the help
Thanks
Bill
Just getting ready to install my 6140 in my 2007 FX 2 Sport with Back-up Camera.
I am looking for a tip or idea on running the Video cable from the back and getting it up to the dash so I can plug it into the unit. Any ideas or secrets where to enter into the cab that is easy to get up to the dash.
Appreciate the help
Thanks
Bill
#2
Senior Member
Join Date: Mar 2010
Location: Bark River, MI
Posts: 110
Likes: 0
Received 0 Likes
on
0 Posts
if you have enough length i would run it from the back all the way to the front on the passenger side and take off the plastic shell inside the fender and either drill a hole in the firewall or try and fit it through the rubber grommet that has the orange antenna wire going through it. i fit my 4 gauge power wire through that so i think you will be able to get it through there . its always better to do it right and keep it clean.