k&n cold air intake install problems please help
#1
k&n cold air intake install problems please help
so i just bought a cold air k&n intake, after installing it and following all directions, i turn it on. it was running just fine. i turned the car off and made sure everything was tight and good to go, i touched the maf sensor and made sure it was plugged in good, i turned it back on and it begins idle really funny going in and out and turning off eventually.
i took the car to ford before i screw anything else up and they want 80 to check it out and possibly another 280 plus labor for the maf sensor- if that is the problem.
i took the car to ford before i screw anything else up and they want 80 to check it out and possibly another 280 plus labor for the maf sensor- if that is the problem.
#3
Mark
iTrader: (1)
did you over oil your new filter or is it a dry filter...too much oil on your filter will interfer with the maf sensor operation... did you see a cel...if its the oil on the maf...pull it out and clean it with some carb cleaner...
#4
Senior Member
so i just bought a cold air k&n intake, after installing it and following all directions, i turn it on. it was running just fine. i turned the car off and made sure everything was tight and good to go, i touched the maf sensor and made sure it was plugged in good, i turned it back on and it begins idle really funny going in and out and turning off eventually.
i took the car to ford before i screw anything else up and they want 80 to check it out and possibly another 280 plus labor for the maf sensor- if that is the problem.
i took the car to ford before i screw anything else up and they want 80 to check it out and possibly another 280 plus labor for the maf sensor- if that is the problem.
I had the same problem when I 1st installed my K&N too.
I figured it out pretty quickly. The gasket and the ring that I installed by the TB was sticking out. Had to remove it all and place it in correctly.
Could be the same for you... but maybe not.
#5
Moderator (Ret.)
Check all clamps for looseness; sounds like an air leak.
#6
its a 2006 f150 fx4 5.4l, it was a used kit and it was reoiled before..., but i dont know if that is it for sure, carb and choke cleaner will clean it off? and it will work properly after cleaned with carb and choke cleaner?
Trending Topics
#8
Dry?
Does K N make a dry filter for a 2005 4.6L? Do you know the part number? Is it as good as the oiled?