Help with part identification
#1
Help with part identification
Just finished changing spark plugs on my 04 f150. Read the sticky and it went ok and thankfully I had the lisle tool.
In the process I broke a hose fitting off of a part on the driver side firewall. It's shown in the picture. I'm not sure what the part is but I think I'm going to need to replace it as the piece I broke is a molded part.
To help clarify it's the part in the middle of the picture that is bracketed to the firewall. The top right of the part has the wire connection and then on the bottom left you see the little green fitting. There's another fitting above that that I broke but I assume I'll have to replace that whole bracketed part.
Anyone know what this is called and where I can pick one up from?
In the process I broke a hose fitting off of a part on the driver side firewall. It's shown in the picture. I'm not sure what the part is but I think I'm going to need to replace it as the piece I broke is a molded part.
To help clarify it's the part in the middle of the picture that is bracketed to the firewall. The top right of the part has the wire connection and then on the bottom left you see the little green fitting. There's another fitting above that that I broke but I assume I'll have to replace that whole bracketed part.
Anyone know what this is called and where I can pick one up from?
Last edited by walkerat; 11-10-2014 at 09:30 PM.
#3
Mark
iTrader: (1)
IWE Solenoid .. you need the up-dated version anyways.. it comes with a hood to shield it from water intrusion.
#4
Senior Member
[MENTION=196318]walkerat[/MENTION] - I can't help with the identification of part as I don't recognize it but [MENTION=98499]Spazmonkey05[/MENTION] suggestion sounds right to me.
#5
Mark
iTrader: (1)
oops .. your correct.. my bad