Help: Carver amp installation
#1
Senior Member
Thread Starter
Help: Carver amp installation
Has anyone installed a carver amp in there 2007 f150? Or just amp? I have a supercrew fx2 and was wondering how the installation was on the amp
#2
Senior Member
Not too hard really, run the power cable from the battery through a rubber grommet below the PCM, it will come into the cabin near the fuse block. Run the AV and any speaker cables on the other side. Hook your neg cable up near the amp. If you are installing behind the rear seat on a SCAB, taking the back seat out is a pain, search this site for a video.
The following users liked this post:
hewittsawesome (03-10-2016)
#3
Senior Member
Thread Starter
Not too hard really, run the power cable from the battery through a rubber grommet below the PCM, it will come into the cabin near the fuse block. Run the AV and any speaker cables on the other side. Hook your neg cable up near the amp. If you are installing behind the rear seat on a SCAB, taking the back seat out is a pain, search this site for a video.