heated seat work on remote starter done
#1
heated seat work on remote starter done
scuse my english im french from quebec .i put picture if you need later
what you need
wiring
switch for heat seat like that
http://www.ebay.ca/itm/251801565661?...%3AMEBIDX%3AIT
relay 4 pin or 5
a timer but not necessary
http://www.ebay.ca/itm/121672288303?...%3AMEBIDX%3AIT
if you want to put your heated seat on when you start your f150 with your remote starter you need to cut the wiring of the 2 part of the seat below the seat . 2 black wire from a connector and a green with orange strip yellow with blue stripe from the other
now connect a black to a ground wiring on the connecter below the seat for electric seat motor. a big black wire
connnect the other black with the yellow with blue stripe wire and route the green with orange stripe behind the heat module, now you need to find a wire on the back of the heat module he have 12v on the remote and on the switch when the ford run . but no 12v when is off (white with violet stripe )
take your 12 volt on it for the switch and the timer (i put a timer 15 minute after it go off.i dont need to put my switch to off and forget it the next time i take it off)
take a good 12 v for the relay on the fuse box or at your discretion .
wiring the switch and the relay and you have a heated seat work with the remote and go off after a predetermined time
me i put a second relay to cut the ground of the light of my switch light .when my timer stop the circuit my light go off. i put my switch to off and again at on to heat another 15 minute .but not necessary .
what you need
wiring
switch for heat seat like that
http://www.ebay.ca/itm/251801565661?...%3AMEBIDX%3AIT
relay 4 pin or 5
a timer but not necessary
http://www.ebay.ca/itm/121672288303?...%3AMEBIDX%3AIT
if you want to put your heated seat on when you start your f150 with your remote starter you need to cut the wiring of the 2 part of the seat below the seat . 2 black wire from a connector and a green with orange strip yellow with blue stripe from the other
now connect a black to a ground wiring on the connecter below the seat for electric seat motor. a big black wire
connnect the other black with the yellow with blue stripe wire and route the green with orange stripe behind the heat module, now you need to find a wire on the back of the heat module he have 12v on the remote and on the switch when the ford run . but no 12v when is off (white with violet stripe )
take your 12 volt on it for the switch and the timer (i put a timer 15 minute after it go off.i dont need to put my switch to off and forget it the next time i take it off)
take a good 12 v for the relay on the fuse box or at your discretion .
wiring the switch and the relay and you have a heated seat work with the remote and go off after a predetermined time
me i put a second relay to cut the ground of the light of my switch light .when my timer stop the circuit my light go off. i put my switch to off and again at on to heat another 15 minute .but not necessary .
Last edited by plvezina; 12-06-2015 at 06:58 PM.
#2
the 12v wire behind the heat module was white with violet stripe for take the 12v with the remote starter but no 12v when engine dont run
Last edited by plvezina; 12-06-2015 at 09:44 AM.