Guidance needed
05-24-2016, 06:30 PM
#11
okay I'll see of I am getting power from bat to switchs. All are new but you never know. Any answer on thr number of fuses. I will jump but I have to take battery out to get to low pressure switch.
05-25-2016, 05:41 AM
#12
Mark
iTrader: (1)
I thought the A/C fuse was under the hood in the little fuse box. The pressure switch is what you can jump..
05-25-2016, 12:40 PM
#13
Okay so I am not getting any power to the low pressure switch(Jumped it and ran a test light on it). Now then I pulled both Fuses in the cabin and they were okay. You say there is another ? Okay I see where 32 is for the clutch so I'll pull that but would that have anything to do with not getting power to the low pressure switch? I see a small 4in square or a little bigger box is that the fuse box where another is located?
Last edited by ceasefire49; 05-25-2016 at 12:48 PM.
05-25-2016, 01:08 PM
#14
Mark
iTrader: (1)
yes.. A/C relay in it.
Last edited by techrep; 05-25-2016 at 01:14 PM.
05-25-2016, 02:03 PM
#15
Okay which one is it I found that box I have the top one. I see both have the r202 relay whic I am assuming is the relay and the do1 is the diode.
Last edited by ceasefire49; 05-25-2016 at 02:14 PM.
05-25-2016, 02:15 PM
#16
Mark
iTrader: (1)
Swap RO1 and RO2 see if anything changes.
05-25-2016, 02:52 PM
#17
Yep did that still no power to switches, Everything is tight and clip on tried to jump again Nada checked with testlight no power I am thinking my PCM quit reading it. think putting new diode in would solve the problem.
?
?