Edge Evolution Problem
#1
Junior Member
Thread Starter
Join Date: Jan 2010
Location: Pasadena, Texas
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Edge Evolution Problem
I just installed a Edge Evolution Programmer like a week ago and when its in power program 2 and 3 it feels like it hesitates or like it studers when driving normal but if i punch it, it takes off good with no hesitation. Any suggestions on why its doing this.
2008 F150 Fx2 Sport 5.4, Edge Evolution Programmer, Roush CAI, Flowmasters Dumped, H.I.D. 8000K, 2/4 Drop
2008 F150 Fx2 Sport 5.4, Edge Evolution Programmer, Roush CAI, Flowmasters Dumped, H.I.D. 8000K, 2/4 Drop
Last edited by f7949f7949; 02-08-2010 at 02:12 AM.
#4
The Edge is for stock trucks only. I don't know for sure the Edge is your issue, but it's likely.
You need a Gryphon with custom tunes (http://dygytalworld.ehost-services13...php/Index.html)
You need a Gryphon with custom tunes (http://dygytalworld.ehost-services13...php/Index.html)
#5
Member
Ok, I think I know whats going on since my truck was doing the same. Are you going into the tunes, 2 & 3, and changing up stuff, like timing, shift points, rpm, etc? Not talking about rev limiter or speedo. I used to change up the timing, just .25 and my truck would do a "ka chugga chugga" tryin to get right, then just go WAAHHHHH like a bat out of hell. I noticed that changing up stuff like that was too much for the Edge and my truck. I also noticed that if you flashed to STOCK before you go from one tune to the next, it accepts it better sometimes. Good luck (and yea, Get a Gryphon).