edge evoloution programming
04-25-2009, 12:00 AM
#1
Senior Member
Thread Starter
Join Date: Mar 2009
Posts: 140
Likes: 0
Received 0 Likes
on
0 Posts
edge evoloution programming
can anyone help me wit programing my evolution...im not sure wat to set exactly.... if someone could send me wat there is set at, that would be awesome...i have an 04 fx4 5.4
04-25-2009, 06:46 AM
#3
Combat Trucker
Join Date: Sep 2008
Location: Chester MD and Goldsboro NC
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
right now mines on level 2 just because i dont wanna buy the expensive gas but my rev limiter is set to 6000, all shift points are 5500, shift firmness is 25 and then i adjusted for gears and tire size. read the owners namual to figure out exactly what you want
04-25-2009, 09:18 AM
#4
none.
Join Date: May 2007
Location: West Palm Beach, FL
Posts: 3,840
Likes: 0
Received 98 Likes
on
78 Posts
you really shouldnt go past 5400 rpm. the convertor which is a 12in, begins to balloon at 5500rpm, thus progressing failure of the transmission. 12in convertors do not get anti-balloon plates from the factory. Unless you have a high stall/smaller diameter convertor, stop spinning it that high.
04-25-2009, 06:28 PM
#5
Combat Trucker
Join Date: Sep 2008
Location: Chester MD and Goldsboro NC
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
my whole tranny is rebuilt with heavy duty/performance parts. someone with a stock tranny may not be able to hold up but i know mine can for sure. but thanks for the advice!