eej711

If you have a 2wd, mine has a 2.5" in the front and a 2" block in the back and the back is about an inch higher.

rollingthunder

Ball joints.... Was told they are not replaceable but you have to get the whole arm, it was under warranty so I didn't argue.

However, I may have just had a bad set from the factory- As I've put another 24,000 on since I made that post and no issues..

05RedXLT

its funny i posted this same thing looking for help but got no suggestions

06F150CFCT

True...until you get Moog UCA's which come with a replaceable and greaseable ball joint.

Bshipe22

That's my theorie. I would say some people got bad parts from the factory. It does happen

nickpatton_189

iTrader: (2)

Are the angles that much worse with a 3" vs 2.5"?

rollingthunder

I use my 4 wheel drive a lot..... I would guess more than most people- I've had no issues with my cv shafts and I've had a 3" strut spacer in the front for 65'000 miles. Like mentioned earlier, the only issue I thought I have had with my 3" lift was actually probably a factory defect.

nickpatton_189

iTrader: (2)

Yeah I use mine alot also. Wouldnt wanna be without it cause of broke stuff

eej711

Its all about timing unfortunately and who sees it before it goes to page 2 then further back