3'' suspension lift
#1
Senior Member
Thread Starter
3'' suspension lift
im trying to install a 3 inch skyjacker suspension lift but while looking over the instructions it says i need a spring compressor? is this something that i need to have or is there a way to do it with out one. how much do they usualy run? what size tires could i run after i put this on? i already have a 2.5 in leveling kit. i have a 2006 2wd xl by the way.
#2
Member
I think the 3" will replace your leveling kit, but i'm not sure. It did when I bought my Rancho's QUickLIft for the front.
As for the spring compressor, yes, you need this. You can get them from a local Harbor Freight, maybe an auto parts store has them. Typically they run $25-55 depending on which you get, but all work. You can also take your struts and your new ones to a 4WP store and they can do the coil spring swap for you, for like $80. I'm sure if you dont have a 4WP store around, another local shop should be able to do so.
As for the spring compressor, yes, you need this. You can get them from a local Harbor Freight, maybe an auto parts store has them. Typically they run $25-55 depending on which you get, but all work. You can also take your struts and your new ones to a 4WP store and they can do the coil spring swap for you, for like $80. I'm sure if you dont have a 4WP store around, another local shop should be able to do so.
#4
Senior Member
That's a lot of work for half an inch in the front, as Vano said, you'll need to take the leveling kit off to do this.
You'll probably notice a stiffer ride from the AALs.
You'll probably notice a stiffer ride from the AALs.
#6
sell the level kit here, people are always looking for them. if your new kit calls for a spring compressor i would rent one. it can be a dangerous without one. just ask my friend, mister one eye.
#7
Senior Member