Wildbillcody

So I got new mirrors that have turn signals in them (always wanted em) the truck didn't have em stock! So the signals don't light up when I put the blinker on, how simple/difficult is it to make them work? I REEEEEALLLY want them to work! Any help would be really appreciated!

06F150CFCT

First i would make sure you have the wires in the door connector for signals...you should but it is worth a look. I didnt have signals on mine either and I had the wires in the door already. I had to switch a pin on the connector on the door in order to get my tow mirrors to work so it is probably the same for you. You can look at the connector on the door and look into the connector on the mirrors to see if they match up.

gforceman

I have an 05 xlt and doing the same but I do not have the connectors or wiring g for signal mirrors so I'm currently hard wiring myself.

06F150CFCT

Ouch...well good luck with that. It'll be worth the hassle!

YPJ

Should be a pretty simple, 1-wire hookup. Stock harness should have a ground that you can swap to match a ground pin on the mirror plug. Then just tap a single wire into your front turn signal wire and match it to the pin on the mirror that wants that signal. Hardest part will be running the wire to keep the install looking clean.

gforceman

Found the wires on the driverside kick panel harness. White/ LT blue for pass side. And light green/ white for drivers side

06F150CFCT

There ya go.

Wildbillcody

So, you sliced a wire from there and ran it up to the mirrors?

Don't cha just love how ford makes stuff easier?

gforceman

I trimmed back the insulation. Twisted wires around wire and taped it. And run the other 2 to the green screw next to it done works great .. I installed an led arrow behind the Mirror glass works greeeeat.!!!

18_F-150_XLT_Screw

iTrader: (1)

Let's see pics .... Which turn arrow LEDs did you use... I was wanting to try this.