2-1/16" Dash Clock (or any 2-16" gauge for that matter...)
#1
Punisher
Thread Starter
Join Date: Aug 2009
Location: Atlanta, GA
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
2-1/16" Dash Clock (or any 2-16" gauge for that matter...)
Just installed a dash clock in the cab of my truck in place of that useless space-taker coin holder. What helmet-wearing design engineer came up with that useless crap of plastic?
Anyway... pretty simple install. Used an abrasive cylinder on the dremel to trim away the plastic to make room for the clock/gauge. I ended up with about a 1/16" lip. Trim slowly... test fit... trim more... test fit. It's alot easier to remove a little more to make room than it is to add some back in because it's too loose.
I purchased an AutoMeter Analog clock which comes with color caps for the illumination bulb to match your interior lighting. Only took about 30mins start to finish. That included tapping in to the wiring harness of the radio, solder connections and heat shrink. (aftermarket radio with amps for doors and sub... power to radio is hardly a drain since it's not 'driving' any speakers)
Anyway... pretty simple install. Used an abrasive cylinder on the dremel to trim away the plastic to make room for the clock/gauge. I ended up with about a 1/16" lip. Trim slowly... test fit... trim more... test fit. It's alot easier to remove a little more to make room than it is to add some back in because it's too loose.
I purchased an AutoMeter Analog clock which comes with color caps for the illumination bulb to match your interior lighting. Only took about 30mins start to finish. That included tapping in to the wiring harness of the radio, solder connections and heat shrink. (aftermarket radio with amps for doors and sub... power to radio is hardly a drain since it's not 'driving' any speakers)