04-08's with Dick Cepek Torque Wheels
#1
Junior Member
Thread Starter
Join Date: Feb 2011
Location: Upper Darby, PA
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
04-08's with Dick Cepek Torque Wheels
Planning on running Dick Cepek Torque Wheels (17x8.5) on my 08 4x4. I'm gonna wrap em in a set of 315/70R 17's. Already have a Rough Country 2.5 leveling kit with rear blocks. I know I'll be cutting it close with the back spacing on these wheels (5in). Anbody running this set up or something like it? Any rubbing?
#3
Junior Member
Thread Starter
Join Date: Feb 2011
Location: Upper Darby, PA
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
I ran the same size tires I mentioned in my original post. They're Hankook Dynapro M/T's. Only needed a 2.5 in leveling kit to fit em. I also trimmed about 6-8 inches from the trailing side of the splash guard inside the front fenders because it would rub when I had the wheels cut while reversing. I also trimmed about an inch of of the corners of the lower valance.
#5
Ya its Dipped, Hate Away
315/70/17 BFG AT's. 3" Rough Country level with 2" rear blocks. Just trim the valance about an inch and the back wheel well splash guard up about 6-8 in like you said and you will be fine. Mine only rubbed in reverse and full lock to the left. No more rubbing after the trimming
Trending Topics
#8
Ya its Dipped, Hate Away
Originally Posted by amick218
I have 33x12.50x17 on dick cepeks, dont know any offset info but i only rub a tiny bit doing uturns, and Im not leveled at the moment.
#9
Eat. Sleep. Lift.
Originally Posted by Bshipe22
Level that rig and get some meats under her! 35's
#10
Ok I too have been looking at the same rims but with a 315/70/17 Kelly safari tsr how bad will they rub on a 2007 fx4 with a 3 inch level and 1 inch in the rear just need to know if they won't rub too bad