MHOWELL34

cree isnt terrible. sometimes you get a bad batch, claim warranty... Other than that check your ground if its getting hot

TSAdventurez

Did mine about 2 years ago I used rigid duallys and the original fog light housings

FX4 2004

We're did u get the brackets

Jkurtz359

Good looking setup. After I get my truck back from the body shop I will need to get a hold of you to get that setup for my fog lights. Found out that the front end of our trucks don't like deer.

nickpatton_189

iTrader: (2)

Yep just let me know. A few customers have been buying the led cubes for this install. Maybe if we get enough ppl we could do a small group buy??

FX4 2004

How did u mount them ?

nickpatton_189

iTrader: (2)

with these right here

FX4 2004

We're did you get those ?you made them ?

nickpatton_189

iTrader: (2)

Got them from a forum member on here.

Jreimnitz150

So I started by fog light build today. I ordered 2 sets of pods from [MENTION=60965]nickpatton_189[/MENTION] about a week ago. I decided I wanted to place the pods inside my stock fog light housing rather than make some brackets as many others have. I started by removing the my old 6K HID's from the truck and then took the 3 10mm bolts out of the housings to remove them. Brought them in the house and set the oven to 175 and baked the housings for 10 minutes each which was plenty of temperature and time to heat the silicone that secures the lens and allowed for easy removal. I haven't decided yet if I will put the lens back on after I finish mounting them so I cut away the old silicone incase. I plan on painting the silver housings black before I permanently mount the pods. The pods that Nick sells fit perfectly in the 04-05 housings. I wanted to use the mounting brackets to secure them to the housings so some modification had to be done so everything would fit. Pretty straight forward modification, simply had to drill new bolt holes in the brackets. As of right now I'm in the dry fitting stage. I'll be drilling 2 holes in each housing for the pod bracket bolts to secure through and nut the back side. I'll be drilling these holes in the top of the housings so the lights "hang" from the top rather than sit on the bottom. Wiring will be run out the existing hole in the back of the housing where the OEM lightbulb used to be. I ordered both flood pattern and spot pattern. The spot pattern is towards the inside while the flood pattern is towards the outside of the housing. The flood pattern will be wired into my OEM foglight switch and the spot pattern lights will be run off of a separate switch. So far its looking like there won't have to be any Dremel type modifications to the housing to fit the lights from Nick, which is what I had originally hoped for. There should be plenty of room for adjustment side to side within the housing but up and down will have to be done with the OEM housing adjustment screws due to the tight fit within the housing. Hopefully I'll be finishing these up in the next few days and I'll get finished pics up with any other steps I had to take.