Wire into door panels
#1
Wire into door panels
I just finished installing my audio system and when I was hooking up my door speakers I realized I could not pull wire into the door panel because there is a connector connecting the door to the body does anyone have any tips how to get wires into the door panel with out drilling hopefully
#3
Senior Member
back in the day i would use the factory wire in the door. just connect the wire from your amp or new head unit to the end of the wire that is associated to its speaker.
#4
Senior Member
I had to run a wire to both my driver and passenger door for my running light mirror mod. The only way I could come up with which would result in a clean finish was taking the doors off and drilling a hole through the plastic door jamb.
#6
Senior Member
#7
I did the mirror/turn signal/light mod, too. I used a thin, long, sharp, stiff wire and poked it thru the rubber grommet that hold the wire loom connector. Once it poked thru, I just taped my wires to it and pulled them back thru.