santa06

My car with sliding tires symbol RSC light is on since I bought the truck two weeks ago. It runs fine but light bugs me; have ordered an Autolink 6019 scanner to get a code but haven't received it yet.

Tried to reset light, and was ale to get it to flash following owners manual info ; but it always defaults back to being always lite up.
I suspect it is one the wheel sensors. Any ideas. Roll over stability control would be good to have over the winter here.

09_XLT

Did you buy the truck new or used? If it is used, it could have a tune in it that someone had disabled the traction control. I did this with mine, but I could not stand having the light lit all the time, so I enabled it again.

santa06

I bought it used; but it was a work truck so I doubt it was tuned.

Lots of clicks, over 200k miles so a sensor not working is understandable, nothing lasts for ever.
So the traction control and ABS will still function with the RSC light on ?

santa06

How do I turn the RSC back on ?

I tried owners manual instructions but couldn't do it.

Was it hard to reactivate .

I was easily able to reprogram TPMS when I changed a damaged sensor.

09_XLT

Like I said before, everything I did was through the tuner. First I disabled it then I enabled it. Other than the traction control on the dash, I don't know of any other way of turning it on in a stock truck.

3six7

Check the fuses that operate on this system. Fuse 36 controls RSC and ABS and I think there might be one or two more.

santa06

Thanks for the replies guys. Had no contact with original owner so not sure about a tune being done; kinda doubt it on a XL work truck.

So I checked 36,47,82 etc using a meter with fuses out and no luck everything seems ok.

I have a new scanner ordered that does ABS, airbags etc hoping it might turn up something so I don't have to go to the dealer and bend over.

At least the 4X4 is ok.