Traction Bars
#112
Senior Member
#113
Senior Member
#114
Senior Member
Thread Starter
Last I heard was that the axle brackets were being shortened and a kit was being designed/tested to bolt on stock height to 6" lifted trucks.
I will email Bryan today for a update.
Wayne
I will email Bryan today for a update.
Wayne
#115
Senior Member
#117
Senior Member
ok how do I get in contact with him?
#119
Senior Member
#120
Senior Member
Thread Starter
Got this this email today!
New design has the rear bracket hanging no lower than the shock mounts and has a single mounting hole for the bar. The front was also changed to a single hole with a slightly different layout. These changes were made after analyzing the motion path of the rear axle under full bump and droop to come up with a mounting points and arc’s that worked best. The revised prototype brackets show be back from the laser cutter before Thanksgiving so we can do a final install check and then run production.
Thanks!
Brian
New design has the rear bracket hanging no lower than the shock mounts and has a single mounting hole for the bar. The front was also changed to a single hole with a slightly different layout. These changes were made after analyzing the motion path of the rear axle under full bump and droop to come up with a mounting points and arc’s that worked best. The revised prototype brackets show be back from the laser cutter before Thanksgiving so we can do a final install check and then run production.
Thanks!
Brian
The following users liked this post:
sigma pi (11-20-2014)