Topic Sponsor
2009 - 2014 Ford F150 General discussion on 2009 - 2014 Ford F150 truck.
Sponsored by:
Sponsored by:

Towing upgrade?

Thread Tools
 
Search this Thread
 
Old 08-29-2016, 02:01 PM
  #1  
Senior Member
Thread Starter
 
1stTruckGuy's Avatar
 
Join Date: Sep 2012
Posts: 742
Likes: 0
Received 79 Likes on 65 Posts

Default Towing upgrade?

I currently have a 5.0 with 3.55 gears and stock tire size (LT tires though). I have the opportunity to purchase a 2010 f250 crew long bed with the V10 motor and 5 speed transmission. Anyone towed with one of them and can provide a comparison? I tow mostly in mountains, with 6200 pound trailer and 5 people in the truck with generator and firewood in the bed. It's pretty taxing on my truck and she spends lots of time in 2nd gear dumping heat into the transmission fluid while we scream up long hills.

I'm looking to ease the towing experience. The v10 has 4.10 gears and 35k miles along with airbags and on board compressor. It drives nice but doesn't have the zip of my unloaded f150 but supposedly has 400ft pounds of torque down lower in the rpm band....?

Also looked at a 10 F150 with 3.73 gears and the 5.4,would it be noticeably better since it also has more low rpm torque and lower gears?
Old 08-29-2016, 02:14 PM
  #2  
Senior Member
 
seanm243's Avatar
 
Join Date: Dec 2015
Location: Tampa, FL & Auburn, AL
Posts: 273
Received 26 Likes on 21 Posts
Default

I'd think the F250 would be about the same as your F150 except it would ride harder. You may be able to get out cheaper if you re-gear your 5.0. I also think if I'm not mistaken that the 5.0 has more power than the 5.4, just higher up in the rpm range. Don't forget, Your F150 has one more gear than the F250. Unless you want a diesel or an eco, I think you're in the best truck you can be.
Old 08-29-2016, 03:41 PM
  #3  
Senior Member
Thread Starter
 
1stTruckGuy's Avatar
 
Join Date: Sep 2012
Posts: 742
Likes: 0
Received 79 Likes on 65 Posts

Default

I'm running stock tire size and always will, but don't know if I'm ready to jump to raptor gears (4.10?),but everyone says going from 3.55 to 3.73 is not worth the cost and you might as well go to 4.10. However most of those folks are also lifted with larger tires so numerically they are probably closer to 3.73 anyway when you account for the bigger tires. The f250 would give me a huge payload bump and an 8ft bed, but that could also make small camp grounds difficult to Maneuver.
Old 08-29-2016, 04:52 PM
  #4  
Senior Member
 
seanm243's Avatar
 
Join Date: Dec 2015
Location: Tampa, FL & Auburn, AL
Posts: 273
Received 26 Likes on 21 Posts
Default

But, the F250 will also get far worse gas mileage and be a generation behind what you currently own. The V10 is also gutless from what I've heard and is pretty much a 5.4 with two more cylinders. I have the 3.73 and realistically, the only thing I would go with for more power towing is a diesel. Don't forget also that the 5.0 was built to go that high in the rev range. By the way, that 8 foot bed makes anything difficult to maneuver around compared to a 5.5 or a 6.5 foot bed.
Old 08-29-2016, 05:01 PM
  #5  
Senior Member
Thread Starter
 
1stTruckGuy's Avatar
 
Join Date: Sep 2012
Posts: 742
Likes: 0
Received 79 Likes on 65 Posts

Default

But the torque converter does not lock in 2nd gear so if you are pulling a hill in 2nd it's generating gobs of heat that the small transmission cooler cannot dissipate effectively. Just something to be aware of if you tow. Yes, the motor revs out just fine to 4k and has plenty of power there but those high revs are not good for the transmission....
Old 08-29-2016, 05:23 PM
  #6  
Senior Member
 
WXman's Avatar
 
Join Date: Jan 2016
Location: Kentucky
Posts: 1,504
Received 310 Likes on 238 Posts
Default

I haven't heard much positive about the V10. Guys I know who drive them complain of horrendous fuel economy and lots of repairs needed as the miles rack up.
Old 08-29-2016, 05:24 PM
  #7  
Senior Member
 
paintballdude05's Avatar
 
Join Date: Aug 2013
Location: Sudbury, Ontario
Posts: 1,244
Received 141 Likes on 135 Posts

Default

Is there a way you could swing a 6.2 SuperDuty? Your other option might be upgrading your existing truck (bigger tranny fluid cooler, rear bags, regearing).
Old 08-29-2016, 06:21 PM
  #8  
Senior Member
 
MattXLT's Avatar
 
Join Date: Sep 2010
Location: Wisconsin
Posts: 444
Received 146 Likes on 95 Posts

Default

Any Super Duty, newer than say 2010 or so, once loaded with gear and passengers rides like a dream. Actually, they aren't bad at all empty either. I have 7 of them at work and love how smooth they ride. They've come a long way from the heavy duty pickups our ancestors had to drive!
The v10 is pretty stout for power, sometimes feels like a pig when it's not working hard but when it's loaded down it doesn't break a sweat.
I say you're on the right track going to an F-250 assuming you make those types of trips often and would get a better return (use) on the investment.
Old 08-29-2016, 07:06 PM
  #9  
Senior Member
 
Davidmackv's Avatar
 
Join Date: Aug 2016
Posts: 233
Received 21 Likes on 21 Posts
Default

V-10 burns up coil packs like crazy. I know this from experience, not word of mouth.
Old 08-29-2016, 07:30 PM
  #10  
Senior Member
Thread Starter
 
1stTruckGuy's Avatar
 
Join Date: Sep 2012
Posts: 742
Likes: 0
Received 79 Likes on 65 Posts

Default

Just to clarify, the v10 in question is the 3v motor from 05+ and has the 5speed auto...


Quick Reply: Towing upgrade?



All times are GMT -4. The time now is 10:41 AM.