tbgreen89

Haha. Yeah I'll take some tomorrow and post it.

2003_lightning

I think I found my setup just with trail grapplers instead

Slowfly

Depends on the wheel but it will be tight in the front, rear is fine. I'm running 315/70/17 Duratracs on a 2.5" 8x17 +20 wheel 2.5" level nothing on the rear yet but may add a 1" block later. It works had to trim some of the bumper valace looks good though. Good Luck..

Paxford

Breck, are you planning on stock rims (32 mm offset 5.75 bs)? They may be your best bet with a 325/70/17 if (big if) the tire doesn't rub at the upper control arm. If it does you might squeeze the tire in with a 25 or 20 mm offset (5.5 or 5.25 bs). As you get closer to 20 mm offset, the tire will move towards the valance, and you'll have to cut more, but will move away from the upper control arm. Find the balance between the two and it might just fit. Can't wait to see pics of that setup. Not sure if anyone else posted this but it's a nifty offset/backspace calculator

http://www.mrw-wheels.com/wheel%20te...t%20chart.html


Oh, and Breck, 4 wheel drive, correct?

jwill8957

In the market for some wheels and tires, I have a 2011 Scab with 2 " Daystar Leveling kit. Id like to run 295/70/18s. Will I be able to fit these tires on the stock wheel incase I don't buy rims right away, and when I buy new wheels what offset do yous normally run. I don't want them sticking out super far thanks!

bodam

I'm pretty sure that I have a 1.5" level kit. 2013 2wd SCREW Lariat


I'm thinking of a set of wheels with +15 offset, with 275-60-20 tires, either Terras or Cooper LTZ.


How much are those going to stick out from the stockers, and will I have any rubbing issues?

Breck3432

Yes it is 4wd

Aldorann

Will the Raptor wheels work on a 2010 STX 2WD Supercab? I have a 2.5" Ready Lift kit installed.

Csortor24

I have a 2010 super crew 2wd xlt, planning to put a leveling kit on it so I can put some bigger tires on. 2wd Xlt sit 2 inch lower in front and come with no block(atleast mine doesn't) so I found a 2.5 rough country level that comes a 1 inch block just incase the 2.5 is nose high. I also will pribay put on 33 inch tires because I don't think 35's will fit, but rim offset is my question! +12 or 0? I don't want them to stick out a lot but I want alittle tire to stick out with no rubbing!

All in all my question is, will my wishful thinking work? Or is there something that should be changed?

White13Ecoboost

I got a 13 4x4 with the rough country 2.5front 1back kit with 33x12.5 or 305/55/20 and my rim is 8.5 offset and I had a little trimming on my front wheel well in the plastic both front and back. With that setup my tires stick out about an inch and I glad I went with that setup because I for like it sticking out to far either.