Stage3Motorsports

Nice, really clean look.

white_dc

iTrader: (12)

Nice work... I was eyeing those spindles on ebay as well when he was selling them.

What did you end up doing about the different in front track width between the front and rear wheels? Spacers?

QCFX2

No spacers as of now. If I see uneven wear or anything feeling different I may but it's only .5" wider per side

03Scott

iTrader: (1)

Nice truck! I wish I was able to get mine sitting like that but the 4x4 system wouldn't be too happy with the axle angles.

QCFX2

Angles have actually been put back to stock for the UCA angles. Not sure what you mean about axle angles.

03Scott

iTrader: (1)

I figured they did that for the UCA but the CV joints on the half axles would be crazy with these. At first I thought you had a 4x4 since I saw the tie rods and thought they were half axles but when I went on their site it said 2 wheel drive only.

buster096

Spindle lifts lift the truck by moving the wheel bearing and studs 4" lower on the spindle. It is the same size spindle as stock but won't work with 4wd because you would have to try and move your cv 4" down to mount it into the hub. Angles would be the same as stock for everything but the cv, the cv angle would be like if you put a 4" leveling kit on lol.

03Scott

iTrader: (1)

Yep, I just want another inch out of the front but it's too much for stock set up and don't want to go to a mid travel or lift kit. This kit make it look good to get to the raptor height.

white_dc

iTrader: (12)

What width wheels are you running? I wouldnt normally worry about the .5" per side but im already running a 20x10 -24 wheel.

I'd like to still do the 4" spindles in the future, but Im still on a 33" tire and it will probably look silly.

GotHonks?

That is Bad A** , Dang good price on those spindles , but damn it they only have them for 2wd ..unless you buy a kit that's over 5k .... curious if they would fit the 4wd ? Oh well .... Nice build ...looks great