justjimmy

Wow, those look really nice and sit perfectly. Nice job.

I have stock FX wheels with 33x12.5 Grapplers on a 4" lift - no spacers. (FX4)

Will be getting 35x11.5 in several months with new wheels as well. Might consider skipping the new wheels and just get the rubber.

Looks real good on yours.

Decisions, decisions.

Tlrmade

1.5" level. Was going to go with 1.5" spacers. 285/65/20 Trail Grapplers on stock 20" wheels. Anybody done this wheels size? Can I go bigger and not rub? Thanks!

DrillRig52

Over 400 posts in this thread and not a single person has pictures of 18" FX4 wheels with spacers lol.

Brett2013fx4

I'm gonna be ordering some 2" bora at the end of the week

flamehead16

i finaly got my bora wheel spacers in. what did you all use to clean up the brake rotor? aslo what torque spec. sheet says manufacturer spec

smgfx4

I don't think I'd try and clean my brake rotor. I'd clean the part that the wheel mounts to, around the wheel studs, with a wire brush to nock the rust off. Then I'd coat it with never seize.

Good luck!

I'd also use locktite on my wheel studs

flamehead16

i got red locktite but the guy at orlieys said i would never get the lug nut off if i used red.

DrillRig52

I would use blue locktite, red could potentially snap studs when you go to remove. Oh and don't confuse blue with green!

Atlee

OEM 17" wheels, no spacers.

Brett2013fx4

Well finally got mine in and will be installing mine at or after work today. Here's some before pics