Show me your Sterling Gray!!!
The following users liked this post:
PirateRugger (07-07-2015)
#2992
Junior Member
#2993
Junior Member
Haven't posted many pics of my '13 Lariat but here is an updated one. Just got back from the shop where I had a 2" Readylift leveling kit installed along with 20x9 Fuel Mavericks and 305/55R20 Nitto Terra Grappler G2s. Other mods include AMP power steps, lower grill off a '14 and a TonnoPro trifold. What do you guys think?
Last edited by F150LINY; 07-08-2015 at 07:05 PM.
#2994
Senior Member
Show me your Sterling Gray!!!
Haven't posted many pics of my '13 Lariat but here is an updated one. Just got back from the shop where I had a 2" Readylift leveling kit installed along with 20x9 Fuel Mavericks and 305/55R20 Nitto Terra Grappler G2s. Other mods include AMP power steps, lower grill off a '14 and a TonnoPro trifold. What do you guys think?
#2997
Senior Member
Show me your Sterling Gray!!!
Originally Posted by F150LINY
Thanks guys, next mods will include tint on front windows and some mats but haven't decided on a brand yet. Probably Weathertechs.
#2999
Senior Member
Show me your Sterling Gray!!!
Anyone know of a good rattle can touch up paint for our trucks?
I had body work done to remove rust. The paint started to bubble, so I went to remove the rust and attack it with inhibitor and put flares over it. Turns out it was bondo that was bubbling, and not rust. Either way, I'm mid repair, but some of the grinding is above where the flares will go.
Rather than pay my buddy the $250 to get painted before the flares get installed, I'd rather just rattle can it. My flares only show about 1/4-1/2" of the bondo I used to replace the stuff I ground out.
I had body work done to remove rust. The paint started to bubble, so I went to remove the rust and attack it with inhibitor and put flares over it. Turns out it was bondo that was bubbling, and not rust. Either way, I'm mid repair, but some of the grinding is above where the flares will go.
Rather than pay my buddy the $250 to get painted before the flares get installed, I'd rather just rattle can it. My flares only show about 1/4-1/2" of the bondo I used to replace the stuff I ground out.