This is that retrofit thread we talked about!
#211
Senior Member
#212
Senior Member
When you remove them put them in bags (completely sealed is better) and DON'T take them out until you finish everything. This helps to keep dust down to a minimum. If you're painting the bezels remove them right away and then put the lenses in bags. Before sealing the heads blow the lenses off with compressed air but do not wipe them with anything because they scratch VERY easily. That's why it's important to keep them clean.
#215
In Dale we trust.
So I went to install the bulbs and ballasts to start test fitting. I attached the ballast into the back of the bulb, went to twist and lock, and it won't fit? Like I can't twist the back of the bulb into the orange fitting, the two ***** don't go deep enough down. Whats happening?
#216
Senior Member
So I went to install the bulbs and ballasts to start test fitting. I attached the ballast into the back of the bulb, went to twist and lock, and it won't fit? Like I can't twist the back of the bulb into the orange fitting, the two ***** don't go deep enough down. Whats happening?
#219
Modification Addict
I bet if the OP posted some more yoga pants then it would flourish again LOL but then again you are attracting the wrong type of attention..... Props to you guys for DIYing your retros I do not have the patients or skill for that....Tux is working on mine should be done shortly