Raptor third brake light installed!!
#141
Insolent Member
If you have hill descent control it is plug and play
The following 2 users liked this post by lariut:
Bryce919er (11-16-2014),
Commeeche (09-14-2014)
#142
End of the Earth
Finished!
Was a lot easier than I thought it would be. I did end up loosening the 7mm bolts above where the rear seat belts come out so I could move that panel a little bit more easily to get the wire tucked behind it. The light is just plasti-dip'd for the time being, except for the 3 LED's, until I can get it tinted right.
Was a lot easier than I thought it would be. I did end up loosening the 7mm bolts above where the rear seat belts come out so I could move that panel a little bit more easily to get the wire tucked behind it. The light is just plasti-dip'd for the time being, except for the 3 LED's, until I can get it tinted right.
#143
End of the Earth
No lights.
Running lights.
Brake lights.
Video goes brake lights, running lights, and then running lights with brake lights.
Running lights.
Brake lights.
Video goes brake lights, running lights, and then running lights with brake lights.
The following users liked this post:
sigma pi (05-14-2015)
#145
End of the Earth
#146
I just installed mine today with the help of my cousin. I have a 2009 f150 XLT and it wasn't plug and play at all. The plugs are different. I removed the wires from the plugs and transferred then back to my original plug with the fourth wire (black with white stripe) hanging freely. You can just tape it off. I then ran a wire to the fuse box below the glove box and for my truck I had to insert the add a circuit to the fuse 22 and then had the same problem with the leds on the new light not turning off. It made no sense to me but that's what would happen. I then decided to run the wire below the rear driver side door and spliced into the wire going to my tail lights for running lights which for my truck was purple with a white stripe. And it worked perfectly. Hope this helps!! And thanks to everyone who posted on here. You guys were helpful.
#147
Maybe someone can help me out with this. Im trying to remove the two headliner push pins on my supercrew to drop the headliner and unclip my third brake light. Ive been pulling pretty hard and they don't seem to wanna come out...Do I just pull harder? I wanted to make sure before I broke anything trying to get the damn things off lol
#148
Boost :)
Maybe someone can help me out with this. Im trying to remove the two headliner push pins on my supercrew to drop the headliner and unclip my third brake light. Ive been pulling pretty hard and they don't seem to wanna come out...Do I just pull harder? I wanted to make sure before I broke anything trying to get the damn things off lol
#150
Senior Member
Read the entire thread, like the idea of the red running lights up high. Has anyone ever consider using red led single lights and just adding them to their existing 3rd brake light.
They come up to 10mm in diameter all you would have to do is remove light drill 3 holes silicone them in and wire. Would be under $10.00 investment.
They come up to 10mm in diameter all you would have to do is remove light drill 3 holes silicone them in and wire. Would be under $10.00 investment.