Off road LED light switches - where did you mount?
The following users liked this post:
Baloo76 (12-17-2014)
#24
You can buy factory automotive dash plastic blacnks from Scoshe. Get it online or crutch field or best buy. Take the dash panel off and fill in the hole with it. I drilled a one inch hole first in the back of the factory cubby hole to be able to run wires. Leave the Scoshe patch blank until u know where u are going to mount your switches. Then cut out with a Dremel and u will already have a clear path ready to run wires.
A good tip that really saves time...Get a piece of string and run it up below the dash and out the hole u drilled in the factory cubby. Leave it there. When u are ready to Dremel cut your holes for the switches, the string is lying there already and you can simply tie your wires onto the end of the string and pull them through
A good tip that really saves time...Get a piece of string and run it up below the dash and out the hole u drilled in the factory cubby. Leave it there. When u are ready to Dremel cut your holes for the switches, the string is lying there already and you can simply tie your wires onto the end of the string and pull them through
The following users liked this post:
f150dave2002 (07-13-2013)
#26
Senior Member
Thanks!
Chris
The following 4 users liked this post by whitescrew77:
#28
Senior Member
#29
Blackhawk CrewChief
I have a set of rigid duallys and just wired them into my fog lights. That way one controls both. The led's don't pull enough watts to hurt the fuse any.