Anyone familiar with this Airlift Kit?
03-16-2015, 08:03 PM
#1
Senior Member
Thread Starter
Anyone familiar with this Airlift Kit?
I'm interested in putting this kit on my truck before driving back to the Midwest with a 20ft trailor. Has anyone ever tried this out?
Last edited by H-60 Electrician; 03-16-2015 at 08:05 PM.
03-16-2015, 08:12 PM
#2
I bought the Air Lift Ride Control kit, 2000 lb load capacity. Installation was easy and have had them on for a year or so now. Works fine for my hauling and loading needs.
Bought mine at AutoAnything, always running discounts and they have the $100 rebat going on now as well.
http://www.autoanything.com/suspensi...A2966A0A0.aspx
Bought mine at AutoAnything, always running discounts and they have the $100 rebat going on now as well.
http://www.autoanything.com/suspensi...A2966A0A0.aspx
03-16-2015, 08:19 PM
#3
Senior Member
Thread Starter
I bought the Air Lift Ride Control kit, 2000 lb load capacity. Installation was easy and have had them on for a year or so now. Works fine for my hauling and loading needs.
Bought mine at AutoAnything, always running discounts and they have the $100 rebat going on now as well.
http://www.autoanything.com/suspensi...A2966A0A0.aspx
Bought mine at AutoAnything, always running discounts and they have the $100 rebat going on now as well.
http://www.autoanything.com/suspensi...A2966A0A0.aspx
Actually, I'm on Autoanything page right now. They are only about 20 miles from me. I appreciate your input. Did you install the wireless load controller as well?
03-16-2015, 10:36 PM
#4
No, I already had a Viair compressor and tank installed before I bought the bags. I have a switch and the pressure gauge mounted in my glove compartment.
The only PIA for me was getting the brackets under the aftermarket rear wheel fender liners and routing the air line through the liner. Didn't want to trim the liner but everything squeezed up tight when I bolted everything in. I also cut off the excess bolts on the bracket that mounts over the leaf springs.
The only PIA for me was getting the brackets under the aftermarket rear wheel fender liners and routing the air line through the liner. Didn't want to trim the liner but everything squeezed up tight when I bolted everything in. I also cut off the excess bolts on the bracket that mounts over the leaf springs.
Last edited by Old Smoky; 03-16-2015 at 10:40 PM.
The following users liked this post:
H-60 Electrician (03-17-2015)