LED Bedlights
#822
I am sorry for the laziness but I do not want to read through 83 pages of posts to try to find my answer.
I am about to install LED bed lights on my 2013 F150.
Can anyone tell me what colors the wire for the cargo light is? Also which side of the cab does the wire run down?
Thanks for you help.
I am about to install LED bed lights on my 2013 F150.
Can anyone tell me what colors the wire for the cargo light is? Also which side of the cab does the wire run down?
Thanks for you help.
The following users liked this post:
AAB77 (12-09-2014)
#825
suienger quick question regarding the pin switch
guessing you drilled a hole to install the pin switch but how did you connect the ground and spade connector to the pin switch
i guess i'm asking if i remove the tail light is it easy to get to that spot for the wiring
thanks
Steve
#826
One Clean Machine
iTrader: (5)
suienger quick question regarding the pin switch
guessing you drilled a hole to install the pin switch but how did you connect the ground and spade connector to the pin switch
i guess i'm asking if i remove the tail light is it easy to get to that spot for the wiring
thanks
Steve
guessing you drilled a hole to install the pin switch but how did you connect the ground and spade connector to the pin switch
i guess i'm asking if i remove the tail light is it easy to get to that spot for the wiring
thanks
Steve
#827
Senior Member
iTrader: (1)
suienger quick question regarding the pin switch
guessing you drilled a hole to install the pin switch but how did you connect the ground and spade connector to the pin switch
i guess i'm asking if i remove the tail light is it easy to get to that spot for the wiring
thanks
Steve
guessing you drilled a hole to install the pin switch but how did you connect the ground and spade connector to the pin switch
i guess i'm asking if i remove the tail light is it easy to get to that spot for the wiring
thanks
Steve
#828
Senior Member
I used one of these rubberized pin switches. It requires a 3/8 - 1/2" or so hole which was large enough for me to fish all the wire through without having to remove the tail lamp. I didn't even bother to put a screw in the secondary hole. It held itself in perfectly well.
psc=1&redirect=true&ref_=oh_aui_detailpage_o01_s00"]Install Bay FMPSR Pin Switch Flange Mount Rubber Boot Each: Amazon.ca: Electronics
#829
suienger quick question regarding the pin switch
guessing you drilled a hole to install the pin switch but how did you connect the ground and spade connector to the pin switch
i guess i'm asking if i remove the tail light is it easy to get to that spot for the wiring
thanks
Steve
guessing you drilled a hole to install the pin switch but how did you connect the ground and spade connector to the pin switch
i guess i'm asking if i remove the tail light is it easy to get to that spot for the wiring
thanks
Steve