Offset/rubbing for dummies
#1
Senior Member
Thread Starter
Offset/rubbing for dummies
Hi forum members. Seeking some expertise. I'm sure there's a thread for this but for the life of me I can't find it.
I drive a 2012 f150 platinum 3.5L EB. Have a 2" level in the front.
I'm looking at getting 20x10 fuel wheels with -19mm offset. See pic of the rim style below.
Can anyone with experience or knowledge related to this let me know whether they think this will be an issue? I have no experience and a very basic understanding about offset. Any/all productive feedback is much appreciated. Thanks!
I drive a 2012 f150 platinum 3.5L EB. Have a 2" level in the front.
I'm looking at getting 20x10 fuel wheels with -19mm offset. See pic of the rim style below.
Can anyone with experience or knowledge related to this let me know whether they think this will be an issue? I have no experience and a very basic understanding about offset. Any/all productive feedback is much appreciated. Thanks!
#2
kyle
what tire size you plan on running?
i ran 305 55 20s on 20x10 -24 ona levelled fx4 and i had to cut plastic fender liner and trim bumper valance and little bit of hammer love on the inner fender.
i ran 305 55 20s on 20x10 -24 ona levelled fx4 and i had to cut plastic fender liner and trim bumper valance and little bit of hammer love on the inner fender.
#3
Senior Member
There's a couple tire threads that are stickies with some helpful information.
#4
Senior Member
Thread Starter
#5
Senior Member
Thread Starter
Hey any chance you have a side profile of your setup? Things change and a 6" BDS lift is being ordered. So I'm putting on 35x12.5xR20 on the same wheels (20x10 -19mm). However in Canada they're sticky about wheels poking out unprotected.
Can you post a pic showing how far your tires stick out? Need to figure out if I can get away with 1" fender flare are if I need 2.5".
Thanks a bunch!