finally joining the club
The following users liked this post:
FormerGMCdriver (05-31-2014)
#3
Senior Member
The following users liked this post:
FormerGMCdriver (05-31-2014)
#4
Junior Member
Thread Starter
I am trying to get used to everything, finally got my phone to sync, I am hoping to find the keypad code... I have been reading about some great mods on here but I am just enjoying it for now
#5
2014 STX SCREW
iTrader: (1)
See if this helps:
Note: you will need to have two programmed passive anti-theft keys for this procedure.
To display the factory set code in the information display:
1.Insert a key into the ignition and turn the ignition on for a few seconds.
2.Turn the ignition off and remove the key.
3.insert the second key into the ignition and turn the ignition on.
The factory set code will display for a few seconds.
Note: The code may not display until after any other warning messages first appear.
Note: you will need to have two programmed passive anti-theft keys for this procedure.
To display the factory set code in the information display:
1.Insert a key into the ignition and turn the ignition on for a few seconds.
2.Turn the ignition off and remove the key.
3.insert the second key into the ignition and turn the ignition on.
The factory set code will display for a few seconds.
Note: The code may not display until after any other warning messages first appear.
The following users liked this post:
FormerGMCdriver (05-31-2014)
#7
Junior Member
Thread Starter
I am looking at adding vent visors of some type, I like the idea of not having to attach them to the body but some people said they have problems with the in channel ones, any recommendations? also, do the ones for the rear doors go in channel too?
Thanks
Thanks
Trending Topics
The following users liked this post:
FormerGMCdriver (06-02-2014)
#9
2013 Ruby Red FX4 SCrew
I had AVS in channel on my 2010 and now on my 2013. Looks great. In channels on the 2013 were a bit of a pain. The windows have the autosensing, so my windows had to relearn with the visors installed. With my 2010, there was no issue cuz that year didn't have that option. So your truck should be fine with the inchannels
The following users liked this post:
FormerGMCdriver (06-02-2014)