beef_stew

Just got done installing these oem style fender flares I got off eBay for about $115 or so. Shout out to mbullock for giving me some advice on how to paint these. I was sent textured finish rather than smooth like I ordered, but mbullock gave me advice and I sprayed it with all professional supplies and it turned out really nice. The clear has a decent amount of orange peel due to the fact that the flares are textured. But all in all I'm very happy and they fit very good too. They have double sided tape on the back side but I used a rubber gasket off some bushwacker flares, rather than the tape to run along the edge to prevent rubbing. It fits super tight with the no drill hardware. The mudflaps took a bit to get them fit correctly and that was the hardest part. Pics below

blknout

looks good. where those mud flaps designed for the fender flares or you had them on beforehand.

beef_stew

thanks, I got the mud flaps from eBay as well. The holes didn't line up very good between the aftermarket flares and aftermarket mudflaps. I had to drill 2 new holes in the mudflaps to get them to use the existing hardware. But they were intended to be on a F150 with flares from the factory

IAJack

I detect a theme. That is kinda sexy in a platonic truck kinda way

paintballdude05

Those look good! I've been back and forth on if I want to install mine or not yet, this makes me want to do it!

johnday in BFE

iTrader: (1)

Fine job Aaron! I take it that isn't a rattle can job. Makes me think I might like some flares like that.

beef_stew

haha yes red and black!

Summers22

iTrader: (2)

I'm a sucker for red and black! Very nice! I would have sent the textured back and gotten the smooth flares but overall it looks good.

beef_stew

go for it man!

beef_stew

thanks man! It is indeed all professional PPG paint (prep items, sealer, base, and clear shot out of a sata guns)