waterboyjlw

Last winter I had a heck of a time with the Running Boards on my Larait. The are in too close to the truck to allow me to get good footing on them especially with some snow and ice build up on them and work/snow boots on. So I didn't spend the money on Amp Research running boards but instead spent about $20 and moved the running board out a little. this is the before picture....and below that is the picture of the brackets that I made. I used 1/8" X 1 1/2" angle iron that I picked up at Lowes/Home Depot. The brackets are 6" long, (3) 11/32" holes spaced evenly at 1 15/16" and on centerline of angle iron.

waterboyjlw

It was pretty simple to remove the running boards... just a 13mm socket. here is a picture of the OEM brackets holding the running board in place. So remove the 8 nuts and lift the running board off and set it aside (where it wont get scratched). Install the bracket extensions onto the OEM brackets and use a 1/4-20 X 1" bolt and locknut to hold it in place. Then just put the running board back in place.

waterboyjlw

ANd this is the after installation picture of the running board. It is solid, supports my 300+ pounds and sticks out just far enough that i can get a full foot on it. Also a picture of underside of running board brackets.

1fifty

Man, I really like good simple solutions and you really have one there. Well done and glad it works out for you. Might not work for everyone, but it is a cool fix.

kmaximus

Thanks so much for posting this write up, I've cut 2 of mine at this point and will be finishing up the other 2 tomorrow.

The 2012 FX running boards have different mounting holes on the bottom so sadly I can't follow your great example to the letter but it will be close. I'll post pics once I have the last one cut

hemigod

Nice mod, and cheap. I may have to do this one. Thanks for the pics and writeup.

goldstonj

You should build more and sell them as kits on EBay. I would probably buy one since I don't have access to the right tools to make them myself.

sllydderrr

I'm on this like stink on a monkey!
Thanks for the post.

kbass24emtp

Cool let me know what all the measurements are. I need to do this also. Can't wait to see the pics.

HCFX2013

Totally down to do this....I hate my running boards but I'm too damn freakin cheap to buy some amp boards.