Ebay projector fogs.
#12
#13
These pics show how dim the halo is and how the HID H3 sticks out of the housing. I took pics of the spacer I used (just a bronze bearing I got from the hardware store). Then I notched the bearing for the screws to pass through it. I used longer stainless screws (M3 /50 pitch). Pics of the 2 LEDs and a pic of the rear of the light housing showing slot where the LEDs plug in. Hope this is what you wanted to see, if not ask away
#15
Currently they are taken apart waiting on a new halo setup. Those lenses were a bear to take apart, 15 min @ 250 degrees finally did the trick. Initially I wasn't going to bother with the halo, but I ordered amber halos and thought they would look cool tied into the turn signals. Should be done this week and I'll post pics.
#17
I have a pic of a single fog light output, powered by a 12v drill battery, 20 ft away from my garage door. I held it approximately 18 in from the ground. The second pic is of the new amber HALO, very bright. I wired them up as additional turn signals. The only thing I would do differently is get 55w vs 35w HIDs.