Custom OTRATTW Switch panel
#21
Senior Member
Then the tray is held in with 4 #2 phillips screws.
Last edited by ososlow; 05-27-2015 at 09:29 PM.
#22
Nope super easy.
Like above just put the gear selector in a lower position and just grab the sides and yank it up Its just held on by some clips....Lift the back of it (arm rest side) and it has a bit of a lip at the front that tucks under the radio section. Thats about it, Once thats off the tray has 4 screws.
Like above just put the gear selector in a lower position and just grab the sides and yank it up Its just held on by some clips....Lift the back of it (arm rest side) and it has a bit of a lip at the front that tucks under the radio section. Thats about it, Once thats off the tray has 4 screws.
#23