'11 STX armrest conversion
#1
Member
Thread Starter
'11 STX armrest conversion
Purchased a new STX recently and I am interested in converting my 40/20/40 cloth steel gray center armrest to the one found on the XLT's with cupholders in the armrest assembly. Anybody else made this conversion? What are the OEM Ford part numbers needed?
#3
I'm not sure the colors would match for an STX, but there are some threads of people swapping their bench seat for the (non-flow thru) console in their XLTs. Do a search and you'll find them. Some even have the part numbers listed
#4
Converted Ford Lover
I did this on my 2012 stx. I bought a seat off e-bay from a 2010 xlt that had the cup holders and storage compartment in the back of the fold down portion. I swapped the top portion of that seat with the top portion of my seat so I could retain my storage compartment under the seat bottom and the slide out cup holders in the front on the floor. The fabric pattern is slightly different but you need to look close to tell. The colors match, at least on the gray.
#5
HOPEFUL
iTrader: (1)
I did this too. I bought a used center seat from a 2011 XLT from a member on here who swapped in a console.
it was a bolt in swap and LITERALLY took 20 minutes to remove my stock seat and swap in the XLT. I dont know that anyone has actually bought new parts from Ford to do the swap. I looked it up once and there was A LOT of parts involved with doing it new.
11's & 12's have the same fabric pattern's 09-10 are different but will swap in, center seatbelt will be lap belt only on them.
13's I am not sure yet
it was a bolt in swap and LITERALLY took 20 minutes to remove my stock seat and swap in the XLT. I dont know that anyone has actually bought new parts from Ford to do the swap. I looked it up once and there was A LOT of parts involved with doing it new.
11's & 12's have the same fabric pattern's 09-10 are different but will swap in, center seatbelt will be lap belt only on them.
13's I am not sure yet