Aftermarket Wheel/tire Question!
#1
Senior Member
Thread Starter
Aftermarket Wheel/tire Question!
I have a 2009 screw 4x4, leveled on LT285/75R18 Toyo AT2's which are 34.8" in height and 11.3" in width on stock lariat wheels. I have no rubbing issues at all. Any way, my question is that if I get a 20" rim with a 00mm offset, will I be okay to run either,
A) Federal Couragia mt 35x12.50x20 which is 34.8" in height 12.5" in width (not sure if this is a great tire, but is less expensive, comments, experience?)
B) Nitto Mud Grappler 35x12.50x20 which is 35.04" and 13" in width
C) Toyo m/t 35x12.50x20 same as mud grappler.
I know width is normally what causes the rubbing issue.
Or, should I get a 33 in something, or get a metric toyo in between 34-35 and slightly narrower tire? Just not sure what I will be able to fit with the aftermarket wheel. I don't mind running spacers if I had to.
A) Federal Couragia mt 35x12.50x20 which is 34.8" in height 12.5" in width (not sure if this is a great tire, but is less expensive, comments, experience?)
B) Nitto Mud Grappler 35x12.50x20 which is 35.04" and 13" in width
C) Toyo m/t 35x12.50x20 same as mud grappler.
I know width is normally what causes the rubbing issue.
Or, should I get a 33 in something, or get a metric toyo in between 34-35 and slightly narrower tire? Just not sure what I will be able to fit with the aftermarket wheel. I don't mind running spacers if I had to.
#2
Junior Member
I have the federals on my truck. I have no complaints about them. And get lots of compliments. One thing that helps with clearance is the lugs on the edges are tappered towards the sidewalls. I attached a pic.
#3
Senior Member