5.0nly

When you spend 3 hours in -10 degree weather replacing your passenger side temperature actuator and find out it was the driver side actuator making the noise. ****

SALEEN961

iTrader: (1)

I feel your pain, I think it was -10* when the blend door cable broke on one of my old cars and left the blend door in the full cold position, that was no fun, I'm hoping you at least have partial heat.

5.0nly

Heat is working fine! The noise is just bothering me. Did 09s and 10s have a different location for the driver side actuator? I swear mine is coming from behind the nav screen on my 12

SALEEN961

iTrader: (1)

They seem to be the same from 09-14. Trucks with dual zone climate control will have a driver side temp actuator, but single zone trucks will not. If you have one it will be just above the floor at the very bottom of the HVAC box in the center of the dash, this is the only one that's hard to replace, but if you aren't too concerned with cutting corners, there are some short cuts to save several hours, Fordtechmakuloco did a video on these and how to cut the time way down.

M0RRIS

Spiky

You shouldn't judge this on noise, but on function. There are 4 actuators, I think they can all sound pretty much the same when clicking. Driver temp, Passenger temp, Source (outside/recirc), Inside distribution. You should be able to fiddle a bit and figure out which function is bad.

I managed to do that (passenger), and then managed to buy the wrong part at first (distribution). Genius!