09 rear view camera
#951
One Clean Machine
iTrader: (5)
Pic...
#952
Senior Member
Does anyone know if the camera can be purchased separate?
I have the bezel and logo just would like to replace the camera with a aftermarket for clearer picture.
I have the bezel and logo just would like to replace the camera with a aftermarket for clearer picture.
#953
https://camera-source.com/automotive...dule-1535.html
This camera is much clearer than the factory one so you will certainly enjoy the upgrade. Also, if your truck is older than 2013 you will want to buy the complete housing/emblem assembly because Ford made a change that not only allows the emblem to be removed without breaking it but also changed the plastic blue emblem so that it doesn't fade.
Thanks,
camera-source.com
888-844-9763
#954
Senior Member
Thank you for the link but I would only need the camera with rca outputs and not the bezel.
#955
Regards,
camera-source.com
888-844-9763
#956
Senior Member
Cool just note that some of the early generation camera housings are only compatible with the early generation cameras. In other words if your camera is currently held on with 2 screws you either have to go to Ford to get a replacement camera or replace the housing with the new generation mount. The new cameras are locked in with two tabs that are molded into the housing, then a single screw to hold the entire assembly in place.
Regards,
camera-source.com
888-844-9763
Regards,
camera-source.com
888-844-9763
#958
I found the wire & tested it but now I just have to run the switch.
#959
Would like to add a front camera but would have the same issue on getting the screen on when desired. I have heard of those add on boxes, lockpic, might be the best way to add one.
#960
It works on my factory option stock camera.
(note backup lights turn on also)
The white/blackstripe wire I added.
With the ignition switch turned ahead (running or not, park or in gear), I can turn the camera on when I add +power to my white/blackstripe wire.
(I tied into 1 of the 2 light colored blue wires in the passenger side channel)
I just need to mount & wire attach my switch.
.
(note backup lights turn on also)
The white/blackstripe wire I added.
With the ignition switch turned ahead (running or not, park or in gear), I can turn the camera on when I add +power to my white/blackstripe wire.
(I tied into 1 of the 2 light colored blue wires in the passenger side channel)
I just need to mount & wire attach my switch.
.