KustomFX

iTrader: (3)

Hi,
I'm in process of doing a couple switch panels with the led colors shown on a video to help visualize (give me a few days). I'm in process of finishing my bench test jig.

But in the meantime here's a pic of my truck (it's a 6 switch overhead panel that I took a pic to show the blue in conjunction with the dash lights).
Our interior light have a slight teal hue to them, as the Carling/OTRATTW are more of a Blue.

Thanks,
Brett

steve392

looks good to me. Its been sooooooo dam hot the last week that i didn't even attempt to wire my switches up.

prank

Hey Brett!

This install looks amazing. I just bought a light bar and would love to equip my '13 FX4 with this setup. Have you finalized these switch panels yet? I'd love to order one ASAP.

Thanks!
Chris

KustomFX

iTrader: (3)

Hi Chris,

Thanks, the overhead switch panels are actually shown in this thread:
https://www.f150forum.com/f59/custom...6/#post4929511
I have a few different designs available and if your wanting the OTRATTW switches too, I also have a large selection of SPST switches too.

....And this thread with the cubby hole 3 switch is also available.

Feel free to email me directly at: lethalweapon09@yahoo.com and we can discuss on what you would want.

Thanks,
Brett

brunosplace

Finally had the time to install my panel I bought at the end of June. It looks great, thanks Brett.











Carling Contura V Series Switches (part # V1D2GHNB-AAC00-000). The green upper led lights up with the dash lights, and the amber lower led will illuminate when the switch is in the ON position.



New custom switch rockers came from OTRATTW. They have a very large selection and the ability to print custom legends for you.

KustomFX

iTrader: (3)

brunosplace, that looks great!!!!!!!
Great install.
OTRATTW is awesome!!!!
I am now a distributor for them and stock theirs most popular SPST switches & rockers,... But they are the best source for switches & rockers! They are genuine Carling switches.... Don't get any better than that!

Again, looks great!!!!
Thanks,
Brett

brunosplace

Thanks Brett,

Now I just have to finish all of the wiring. New harnesses have been made and installed from near the battery to the dash and console, along with one to the drivers tail light corner. Just have to finish the fuse/relay block, some splicing, and install the bed led lights.

Joeniel

Besides the obvious fact that the trailer brake controller is in the way, is there any other reason why this would not fit the drivers side of an F150 equipped with the TBC?

KustomFX

iTrader: (3)

Yes, the TBC is in the way. You need the hole completely open. This will only fit if you do not have a TBC or you must remove the TBC.

The hole is the same size as the PASS side cubby. And modifications are required to get the switch panel flat to get the best results .... Shown in post #5.
Some up close pics are shown in the opening posts including the driver side.
Please keep in mind this is a DIY project and even though it is quite simple, it needs to be done right & correct prep to get the best results. Again, all steps are shown in the beginning posts of this thread.

Any questions, feel free to email me.
-Brett

brunosplace

Finally have things wired up. The switch plate makes it all look like it is supposed to be there.