Baja Kits F150 4" Lift Spindle - F150Forum.com Member Discount Inside
#11
Senior Member
They all do except the white FX2, they are running 37's falken wild peak. Spoke with Jordan at Baja aka Brenthal
#13
Senior Member
Need around 0 offset wheel
The following users liked this post:
white_dc (06-29-2014)
#14
Member
@Baja Kits
I'll buy a kit right now if you make a 2" lift spindle, 4" is too high for a level.
Possible? Yes but are ya'll willing to make it? That is the $1,000.00 question.
I sent in a product request for the same info on the website before I found this thread. What say ye?
P.S. I really don't want that .5" out spacing either so if it's possible to make them not stick out farther than stock would be ideal. I would hate to space the rear wheels out to match but will if it's a must.
.
I'll buy a kit right now if you make a 2" lift spindle, 4" is too high for a level.
Possible? Yes but are ya'll willing to make it? That is the $1,000.00 question.
I sent in a product request for the same info on the website before I found this thread. What say ye?
P.S. I really don't want that .5" out spacing either so if it's possible to make them not stick out farther than stock would be ideal. I would hate to space the rear wheels out to match but will if it's a must.
.
Last edited by RLXXI; 07-28-2014 at 01:52 AM.
#15
We don't recommend it as we have not tested it with spacer lifts, nor did we design the geometry of the lift spindle with them in mind. You most likely can use them without issues, but we can't advise that as there are too many unknowns.
#16
The following users liked this post:
16warmachine (04-05-2020)
#17
Baja Kits 4" Spindle Lift Kit by BajaKits
#18
@Baja Kits
I'll buy a kit right now if you make a 2" lift spindle, 4" is too high for a level.
Possible? Yes but are ya'll willing to make it? That is the $1,000.00 question.
I sent in a product request for the same info on the website before I found this thread. What say ye?
P.S. I really don't want that .5" out spacing either so if it's possible to make them not stick out farther than stock would be ideal. I would hate to space the rear wheels out to match but will if it's a must.
.
I'll buy a kit right now if you make a 2" lift spindle, 4" is too high for a level.
Possible? Yes but are ya'll willing to make it? That is the $1,000.00 question.
I sent in a product request for the same info on the website before I found this thread. What say ye?
P.S. I really don't want that .5" out spacing either so if it's possible to make them not stick out farther than stock would be ideal. I would hate to space the rear wheels out to match but will if it's a must.
.
#19
Member