BIG_WHITE_HYPE

I have XD Monsters 20x9 with 5.71" Backspacing and I am wondering how much trimming would be needed, or would it be possible at all to run a 35" or 35.5" Tire with the Rancho 4" Lift.

Is anyone running the 4" Rancho lift with stock 20s or rims with similar backspacing? If so, are you able to run a 35x12.50R20 or 295/65/20 with the 4" Rancho kit on either stock rims, or similarly backspaced rims?

How much trimming was needed?

Thanks for your help!

USMC_0316_RAIDER

Yes I'm pretty positive it's possible. There are a few trucks I saw while searching for my lift that run 35s on the stock 20s. Also UARANDY runs 35s with his kit. I will be also after my 33s wear out.

BIG_WHITE_HYPE

Thanks for your reply. I spoke to Randy but he has a different backspacing. Was hoping someone with the same spacing could confirm or deny.

What are your opinions on putting additional spacers? Someone has suggested adding those. I understand there may be additional stresses added but I'm not doing any off roading.

Thanks for your help!

USMC_0316_RAIDER

I wouldn't go with spacers. I'm not a fan of em. They say on there site what they recommend. Your bs is near stock correct?

BIG_WHITE_HYPE

It's 5.71". Not quite stock.

USMC_0316_RAIDER

Do you know your current offset. ?

BIG_WHITE_HYPE

I think they have a 0 offset. This is the exact line from the invoice if you can understand that, cause I can't.

4 0 W/PXD77829067718 20X9 6X135/6X5.5 5 236.99 947.96 E

USMC_0316_RAIDER

No clue. If your at 0 you should be fine then.