yamaharider529

So here are my choices, Fuel Lethals, TIS Monster Energy 535 or Moto Metal 962. They will be going on my 2013 blacked out F150 FX4. I will be putting 20x9 on it. I'm going to be putting 33's on it probably toyo Mt tires. I have a 2" level on the front. Thanks guys, its just about impossible to pick which rims to get. Lol Here's some pictures of the ones I'm looking at.

RLXXI

I think the fuel wheels look bad ***. I don't care for all that blacking out because I like chrome but those wheels really pop.

Abraham5G

From those three, I like the moto metals the best.

zimmer0

iTrader: (1)

IMO clean, simple wheel. Would prefer a x10 for some lip especially if staying with a 33" tire

yamaharider529

So I started looking at Moto Metals cause I was sold on them but then I seen where they only come in a 0 or -44 offset so I guess that's out cause they will stick out to far for my liking. So now I'm leaning towards the Fuels and getting a +20 offset so it will only stick out about an inch. My first pick were the BMF Novakanes but then again only in a 0 or negative offset. Zimmer what do you mean x10? A 20x10 wheel?

zimmer0

iTrader: (1)

yes, personally think it would look alot better with a lip and a negative offset to give it a wider stance

yamaharider529

Ok let me ask you guys this. I have a 2" front level the back is stock. I can't decide if I should go with a 33x12.50x20 or go with the Nitto Trails in a 295/60/20. I like the idea of the nitto cause it will be a little taller and fill the space up a little bit but will I have to trim more with it? I don't want to really trim at all but of its only on the lower valance that's fine just not on the actual fender well. This will be with a +20 offset wheel, I know the amount of offset matters a lot when it comes to rubbing. Also 9 inch wide wheel. Thanks

Wheel Guru

I know with a level the 33's will fit without trimming but cant say for sure about the 295s the fitment site i use doesnt show anyone running the 295s on a leveled f150.

dcrabby

Moto Metal

Hollabakzach23

Ohhhh I like the motor metals myself too