wiring help
#1
Member
Thread Starter
wiring help
i have four infinity kappas at 4ohms a piece and two jbl seleniums at 8ohms a piece and am curious how to run them off a 4/3/2 channel kenwood amp that can run a MIN bridged 4ohm and unbridged 2ohm i thought about the scametic below but am not sure if its 100%
#2
Senior Member
Basically, you are dealing with ohms laws which states that 2 resistors (speakers) wired in series with be additive and in parallel will be halved. Based on your drawing, they are wired backwards.
Your Jbl Selenium 8 ohm speakers which you show in series should be wired in parallel which would give you 4 ohms.
Your Infinity Kappas need to be wired in series-parallel which will give you 4 ohms. Wire 2 speakers in series (8 ohms) and the other 2 in series (8 ohms) and then wire that in parallel for the 2 sets of 2 which will give you 4 ohms.
I'm not sure of the Kenwood output terminals in your drawing. (front/back) (left right)
Your Jbl Selenium 8 ohm speakers which you show in series should be wired in parallel which would give you 4 ohms.
Your Infinity Kappas need to be wired in series-parallel which will give you 4 ohms. Wire 2 speakers in series (8 ohms) and the other 2 in series (8 ohms) and then wire that in parallel for the 2 sets of 2 which will give you 4 ohms.
I'm not sure of the Kenwood output terminals in your drawing. (front/back) (left right)
#4
Senior Member
Yup, your drawing will give 4 ohms for both sets. I don't understand your question "And a question can I bridge both sets using all four channels?" please clarify.
#7
Senior Member
For instance bridge the seleniums like shown therefor using two channels and then bridging the kappas using the remaining two channels like so
Attachment 339817
Attachment 339817