The ultimate thread for the pac aoem-frd24/ post all info here for all to enjoy
#221
I bought the Kenwood KAC 7005PS. $190 on Amazon. Has pretty good reviews. I also broke down and purchased AudioControl LC6i too. Will hopefully be installing it all soon.
#222
Senior Member
Thanks. I broke down and bought the little alpine amp. Now I'm looking at powered subs. Maybe infinity bass link or sound ordnance. Not sure... I'm catching flack for even thinking about stereo upgrades. Oh well.
#223
hey fellas. I got all my stuff installed - JL 300/4 bridged to some focal comps, and a 250/1 to a jl 10w1...sounds great but I have a nasty hiss. I've turned the gains all the way down on the PAC, which helps but then I get no volume so I bumped it up a tad, just above completely off, then adjusted gains on the amps. The voltage seems really high even at this low level. Are any of you guys getting a white noise from this set? It's not an ignition noise, it's a white, almost static noise.
#224
hey fellas. I got all my stuff installed - JL 300/4 bridged to some focal comps, and a 250/1 to a jl 10w1...sounds great but I have a nasty hiss. I've turned the gains all the way down on the PAC, which helps but then I get no volume so I bumped it up a tad, just above completely off, then adjusted gains on the amps. The voltage seems really high even at this low level. Are any of you guys getting a white noise from this set? It's not an ignition noise, it's a white, almost static noise.
#225
I haven't seen this addressed on this forum. Does all sync and audio get pushed through the PAC? I am using it to run sub amp and it works great I also have a 2ch that I want to run front seperates with. I want to wire straight from amp to crossovers and then onto each component, bypassing all factory stuff. Will this work?
#226
Senior Member
I haven't seen this addressed on this forum. Does all sync and audio get pushed through the PAC? I am using it to run sub amp and it works great I also have a 2ch that I want to run front seperates with. I want to wire straight from amp to crossovers and then onto each component, bypassing all factory stuff. Will this work?
The following users liked this post:
Cadrms (02-15-2014)
#227
Senior Member
hey fellas. I got all my stuff installed - JL 300/4 bridged to some focal comps, and a 250/1 to a jl 10w1...sounds great but I have a nasty hiss. I've turned the gains all the way down on the PAC, which helps but then I get no volume so I bumped it up a tad, just above completely off, then adjusted gains on the amps. The voltage seems really high even at this low level. Are any of you guys getting a white noise from this set? It's not an ignition noise, it's a white, almost static noise.
Setup info:
Alpine KTP 445U (BT-5520 harness)
Infiniti 6.5" components front and rear
Kicker 10" sub powered by Pioneer GMD9601 amp
#229
Senior Member