The ultimate thread for the pac aoem-frd24/ post all info here for all to enjoy
#11
Bump!! Rca to the back, then speaker wire back to the front to grab the front doors from behind the hu sounds great!! Did any of you do this yet? The pac is a lot cheaper then using the bt 5520 and LC6i.. Info PLEASE
#13
I am confused on this product. I'm going to run 2 amps. 1 for front comps and 1 for my sub/s. I see there is 2 RCA inputs on this product but can I connect 2 amps? Or is one of those sets of inputs for the sync or something?
#14
Dazed and Confused
Take a chance and buy one. I did on my 2011. Only showed up to 2010 and works great. I would think it would since 2012 is the same generation. But I have been known to be wrong before.
#15
Dazed and Confused
What type of cab do you have? Both sets of RCA (front and rear) are input to the amp. Not powering the rear speakers? I am no audio guru but what others have said you have some options. Run 2 sets of RCA to the amps and use a Y splitter on one set for input to the sub amp. If not powering rear speakers on some amps I believe you can bridge a channel to power sub.
#17
Dazed and Confused
The 2 sets are for amps with 4 RCA connectors. Usually front/rear. I have a mono sub amp and only used 1 RCA set. I still ran 2 sets of cables just in case I upgraded. What you need to install all depends on the amps you use. A typical 4 channel amp will need 2 RCA cable sets. If you are going to have a separate sub amp you will need to split off of one cable set for input to the sub amp. If you use a 4 channel and bridge for your sub you will only need 2 sets. Clear as mud?
Last edited by Tallyman89; 01-31-2012 at 03:18 PM.
#19
Dazed and Confused