Remote bass control help
#1
Senior Member
Thread Starter
Remote bass control help
I want to get a remote bass control and wanted to make sure I know how to hook it up. I have the factory stereo with the PAC unit. If I wanted to get this remote bass control how would I hook it up?
http://www.sonicelectronix.com/item_...xess-AALC.html
Thanks!
http://www.sonicelectronix.com/item_...xess-AALC.html
Thanks!
#2
Very easily, I did a similar setup except with the PAC LC1. I'm assuming you are using the PAC AOEM-FRD24 to get a signal to send to your Sub Amp. Instead of running the RCA cable straight to your Amp from the PAC interface you run it to the Input on this device, the run another cable from the Output back to your Amp.
The trick is to decide whether you want this **** to turn UP or DOWN your bass. I installed mine to turn OFF the bass with the Wife in the car so I set the bass **** to about 80% then adjusted the output level on the PAC interface, and my Amp to where I want to listen normally. Then I can boost slightly, or kill it. If you want the **** to occasionally crank it, then set your levels on the PAC interface and Amp with the Bass **** low.
Hope this helps.
Here's the **** I used.
http://www.sonicelectronix.com/item_5260_PAC-LC1.html
The trick is to decide whether you want this **** to turn UP or DOWN your bass. I installed mine to turn OFF the bass with the Wife in the car so I set the bass **** to about 80% then adjusted the output level on the PAC interface, and my Amp to where I want to listen normally. Then I can boost slightly, or kill it. If you want the **** to occasionally crank it, then set your levels on the PAC interface and Amp with the Bass **** low.
Hope this helps.
Here's the **** I used.
http://www.sonicelectronix.com/item_5260_PAC-LC1.html
The following users liked this post:
Stenz (12-28-2012)