Help needed for 2012 w/Sony & Nav and adding amp + subs
#11
When I wired mine up, the two Black wires I used are Negative and the Red and Yellow are positive.
Factory Sub wiring looks like:
+ purple with green tracer
- green with white tracer
&
+ green with purple tracer
- gray
The rca has 2 black wires and then a white and red for positive. a red and black is one channel and the white and black is another.
Factory Sub wiring looks like:
+ purple with green tracer
- green with white tracer
&
+ green with purple tracer
- gray
The rca has 2 black wires and then a white and red for positive. a red and black is one channel and the white and black is another.
Last edited by Gremlin85; 01-13-2017 at 02:31 PM.
#12
Senior Member
Thread Starter
Originally Posted by Gremlin85
When I wired mine up, the two Black wires I used are Negative and the Red and Yellow are positive.
Factory Sub wiring looks like:
+ purple with green tracer
- green with white tracer
&
+ green with purple tracer
- gray
The rca has 2 black wires and then a white and red for positive. a red and black is one channel and the white and black is another.
Factory Sub wiring looks like:
+ purple with green tracer
- green with white tracer
&
+ green with purple tracer
- gray
The rca has 2 black wires and then a white and red for positive. a red and black is one channel and the white and black is another.
#14
Senior Member
Thread Starter
Originally Posted by RedAggie03
https://www.f150forum.com/f30/redagg...nstall-318494/
Good luck, just tear into it and you'll get it figured out!
Good luck, just tear into it and you'll get it figured out!
#15
Okay so I did this with a scosh LOC JL jx500-1 and 2 JL 10w0s but mine gets some kind of distortion from somewhere it crackles and pops and sounds terrible, have any of y'all had this problem?
#16
Senior Member
Thread Starter
Originally Posted by JwvickersECO
Okay so I did this with a scosh LOC JL jx500-1 and 2 JL 10w0s but mine gets some kind of distortion from somewhere it crackles and pops and sounds terrible, have any of y'all had this problem?
#17
thanks
#18
Senior Member
Thread Starter
Originally Posted by JwvickersECO
ah sorry, yes I am using the signal from the factory sub harness into the LOC. My truck is a 2014 fx4 with the 8 inch MFT and Sony stereo upgrade. I had seen it done before this way so I can't figure out why it isn't working
thanks
thanks
#19
Hmmm that is weird. The only difference is you have the MFT but if you said you followed someone else do it then that's weird. It could be your LOC...I know the cheap ones have a reputation to do that sometimes. Could just be a faulty one. If the wires are hooked up right then there doesn't leave much else. Have you tried to take the signal from the rear speakers instead to see if you get the same result?
#20
Before changing where you get your signal from, make sure your gain isn't too high on both the LOC and the amp. You might be overpowering the speaker.
I would then make sure your speaker connections are solid and not moving around while the sub is playing.
After that , double-check your ground wire. Make sure it is 18" or shorter and mounted to the body securely and cleanly. Make sure it's not mounted on a painted or greasy surface.
I would then make sure your speaker connections are solid and not moving around while the sub is playing.
After that , double-check your ground wire. Make sure it is 18" or shorter and mounted to the body securely and cleanly. Make sure it's not mounted on a painted or greasy surface.